To configure network settings, go to the sidebar and click on „Network“.
This will open the „Network Settings“ section in the main window.

Inside that section, you'll find a box titled „Network Settings“ with all available options for Ethernet and Wi-Fi.

At the top of the page, you’ll find a dropdown menu to select the interface you want to configure, e.g.:

• Ethernet 1
• Wi-Fi 1
• etc.

⚠️ Settings shown below apply only to the selected interface.

• Enable the „DHCP“ checkbox to let the BMS automatically get its IP settings from your router.

If DHCP is disabled, you need to manually enter:

• IP Addresses:
  • Add at least one
  • Use „+„ to add more, „–“ to remove last
• DNS Nameservers:
  • Same add/remove logic
  • Used to resolve domain names (e.g. grnbms.de)
• Gateway:
  • Usually the IP of your router (e.g. 192.168.1.1)

Wi-Fi interfaces support two modes: Access Point or Client (Station)

If „Use as Access Point“ is checked, enter:

• SSID – WiFi name
• Password – WPA2 key
• IP Address – e.g. 192.168.4.1

📶 Devices can connect directly to this access point for setup.

If Access Point mode is not checked, the interface acts like Ethernet:

• DHCP checkbox
• Or manual:
  • IP Address(es)
  • DNS Servers
  • Gateway