Go to Battery → Pack Configuration in the sidebar to define your battery layout and set current and safety limits.

Number of cells connected in parallel per module.

ℹ️ Note: A module with 12 cells in series (12S) counts as 1 parallel group, regardless of the number of physical cells inside.

Total number of cells in series in your full battery pack.
This value is critical for accurate voltage monitoring and state-of-charge (SOC) calculations.

Set the maximum and minimum charging current as a percentage of the value defined in the selected Battery Type.

💡 Example: If your battery profile allows 200 A max charge current and you set 60%, the BMS will limit to 120 A.

Define four thresholds that trigger system warnings or errors based on current flow:

Charge Warning

Charge Error

Discharge Warning

Discharge Error

Each is set in % of the battery type’s current limit.

⚠️ Important: These limits help protect your system from overcurrent conditions.
Set realistic values based on your hardware capabilities.

Enable this to allow balancing even while errors are active.

⚠️ Caution: Use only for recovery or diagnostics.
In normal operation, this option should remain disabled.

Define how far the battery is allowed to charge or discharge:

Maximum SOC – upper limit (e.g. 90%)

Minimum SOC – lower limit (e.g. 10%) 🔋 Tip: Reducing the usable SOC range can extend battery life significantly.