Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- basic_conditions [2025/01/12 11:46] – grnbms
+++ basic_conditions [2025/01/12 21:07] (aktuell) – grnbms
@@ Zeile 3: / Zeile 3: @@
 **1. Firmware**
-''Check if the BMS and all connected devices have the latest firmware installed. To do this, click on **Updates → Check updates**. If new updates are available, update all devices to the latest version.''
+Check if the BMS and all connected devices have the latest firmware installed.To do this, click on Updates → Check updates on the Overview. If new updates are available, update all devices to the latest version.
 **2. Canbus**
-''It is a prerequisite that the CAN bus is properly terminated!''
+It is a prerequisite that the CAN bus is properly terminated! Disconnect the BMS from the power supply and use a multimeter to measure the resistance between CAN High and CAN Low at the respective CAN port where something is connected. The resistance must be 120 Ohms. If you measure a different value, adjust the termination resistor using the red jumper on the BMS board and repeat the measurement.
-''Disconnect the BMS from the power supply and use a multimeter to measure the resistance between CAN High and CAN Low at the respective CAN port where something is connected. The resistance **must be 120 Ohms**. If you measure a different value, adjust the termination resistor using the red jumper on the BMS board and repeat the measurement.''
+''{{:canbus.jpg?nolink&500x190  |canbus.jpg}}''
-''{{:canbus.jpg?nolink&  }}''