Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- basic_conditions [2025/01/12 11:12] – angelegt grnbms
+++ basic_conditions [2025/01/12 21:07] (aktuell) – grnbms
@@ Zeile 1: / Zeile 1: @@
-. Check if the BMS and all connected devices have the latest firmware installed.
-   To do this, click on **Updates -> Check updates**.
-   If new updates are available, update all devices to the latest version.
+**1. Firmware**
+Check if the BMS and all connected devices have the latest firmware installed.To do this, click on Updates → Check updates on the Overview. If new updates are available, update all devices to the latest version.
+**2. Canbus**
+It is a prerequisite that the CAN bus is properly terminated! Disconnect the BMS from the power supply and use a multimeter to measure the resistance between CAN High and CAN Low at the respective CAN port where something is connected. The resistance must be 120 Ohms. If you measure a different value, adjust the termination resistor using the red jumper on the BMS board and repeat the measurement.
+''{{:canbus.jpg?nolink&500x190  |canbus.jpg}}''