===== Pack Configuration =====

Go to **Battery → Pack Configuration** in the sidebar to define your battery layout and set current and safety limits.
==== Cells in Parallel ====

Number of cells connected **in parallel** per module.

''ℹ️ **Note:** A module with 12 cells in series (12S) counts as **1 parallel group**, regardless of the number of physical cells inside.''
==== Cells in Series ====

Total number of **cells in series** in your full battery pack.\\
This value is critical for accurate voltage monitoring and state-of-charge (SOC) calculations.

==== Max / Min Charge Current ====

Set the **maximum and minimum charging current** as a percentage of the value defined in the selected Battery Type.

''💡 **Example:** If your battery profile allows 200 A max charge current and you set 60%, the BMS will limit to 120 A.''
==== Charge & Discharge Current – Warnings & Errors ====

Define four thresholds that trigger system warnings or errors based on current flow:

  * Charge Warning
  * Charge Error
  * Discharge Warning
  * Discharge Error

Each is set in **% of the battery type’s current limit**.

''⚠️ **Important:**  These limits help protect your system from overcurrent conditions. \\ Set realistic values based on your hardware capabilities.''

==== Balance with Errors ====

Enable this to allow **balancing even while errors are active**.

''⚠️ **Caution:**  Use only for recovery or diagnostics. \\ In normal operation, this option should remain **disabled**.''

==== SOC Limits ====

Define how far the battery is allowed to charge or discharge:

  * **Maximum SOC**  – upper limit (e.g. 90%)
  * **Minimum SOC**  – lower limit (e.g. 10%)
''🔋 **Tip:**  Reducing the usable SOC range can **extend battery life**  significantly.''