network_connection []

Diese Seite ist nicht editierbar. Sie können den Quelltext sehen, jedoch nicht verändern. Kontaktieren Sie den Administrator, wenn Sie glauben, dass hier ein Fehler vorliegt.
===== Network Settings =====

⚠️ ''Power over Ethernet (PoE) is not supported for GRN products and must not be used under any circumstances. The use of PoE with GRN products is strictly prohibited. Any non-compliance with this requirement may result in damage to the equipment. The company assumes no liability for any damages, malfunctions, or consequential losses arising from such misuse.''

To configure network settings, go to the **sidebar** and click on **"Network"**.\\
This will open the **"Network Settings"** section in the main window.

Inside that section, you'll find a box titled **"Network Settings"** with all available options for Ethernet and Wi-Fi.
==== 1. Select Interface ====

At the top of the page, you’ll find a **dropdown menu** to select the interface you want to configure, e.g.:

   * ''Ethernet 1''
  * ''Wi-Fi 1''
  * etc.

''⚠️ Settings shown below apply **only**  to the selected interface.''

==== 2. Ethernet Interface Settings ====

=== DHCP (automatic) ===

  * Enable the **"DHCP"**  checkbox to let the BMS automatically get its IP settings from your router.

=== Static IP (manual) ===

If **DHCP is disabled**, you need to manually enter:

  * **IP Addresses:**
      * Add at least one
      * Use **"+"**  to add more, **"–"**  to remove last
  * **DNS Nameservers:**
      * Same add/remove logic
      * Used to resolve domain names (e.g. grnbms.de)
  * **Gateway:**
      * Usually the IP of your router (e.g. ''192.168.1.1'')

==== 3. Wi-Fi Interface Settings ====

Wi-Fi interfaces support two modes: **Access Point**  or **Client (Station)**

=== ➤ Access Point Mode ===

If **"Use as Access Point"**  is checked, enter:

  * **SSID**  – WiFi name
  * **Password**  – WPA2 key
  * **IP Address**  – e.g. ''192.168.4.1''
''📶 Devices can connect directly to this access point for setup.''

=== ➤ Client Mode (normal Wi-Fi) ===

If Access Point mode is **not**  checked, the interface acts like Ethernet:

  * **DHCP checkbox**
  * Or manual:
      * **IP Address(es)**
      * **DNS Servers**
      * **Gateway**
''💡 Wrong network settings may make the BMS unreachable. Use DHCP if unsure. ''