Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- mk3:switch [2025/04/07 18:28] – angelegt grnbms_tech
+++ mk3:switch [2025/04/07 18:30] (aktuell) – [When System is Active] grnbms_tech
@@ Zeile 4: / Zeile 4: @@
 It allows controlled activation and deactivation of the entire battery system.
-{{:mk3:screenshot2025-04-07200216.png?nolink&300|Battery Switch UI}}
+{{:mk3:screenshot2025-04-07202133.png?nolink&300|Battery Switch UI}}
 ==== System Start-Up ====
@@ Zeile 16: / Zeile 16: @@
 === High Voltage Systems ===
-  *
+  * When **"Power On"**  is pressed, the BMS automatically performs an **isolation test**
+  * If the test passes, the **precharge sequence**  starts, followed by activation of the positive and negative relays
-When **"Power On"**  is pressed, the BMS automatically performs an **isolation test**
+  * The system is now live and ready for operation
-  *
-If the test passes, the **precharge sequence**  starts, followed by activation of the positive and negative relays
-  *
-The system is now live and ready for operation
 === Low Voltage Systems ===
-  *
+  * Same flow as above, **but without isolation test**
+  * Relays are closed after a short delay and the inverter is powered up
-Same flow as above, **but without isolation test**
-  *
-Relays are closed after a short delay and the inverter is powered up
 ----
 ==== When System is Active ====
+{{:mk3:screenshot2025-04-07202141.png?nolink&300}}
 Once relays are engaged, two buttons become visible:
-  *
+  * 🔴 **Emergency Stop**  Instantly disables all relays – use only in emergency situations ''⚠️ Cuts power without any shutdown process. May lead to system faults if used during operation.''
+  * 🔵 **Shutdown**  Recommended method for turning the system off ''Sends a clean shutdown signal to the inverter and safely disconnects all relays afterward''
-🔴 **Emergency Stop** \\ Instantly disables all relays – use only in emergency situations ''⚠️ Cuts power without any shutdown process. May lead to system faults if used during operation.''
+----
-  *
-🔵 **Shutdown** \\ Recommended method for turning the system off ''Sends a clean shutdown signal to the inverter and safely disconnects all relays afterward''
-----
 ==== Status Indicators ====
-  *
+  * **State:**  Shows current switch/test state (e.g. ''Waiting'', ''Testing Isolation'', ''Ready'', ''Error'')
+  * **Relays:**  Displays relay status (e.g. ''Open'', ''Closed'', ''Precharge'', ''Error'') ''🔍 Always check both values before powering on or off the system manually.''
-**State:** \\ Shows current switch/test state (e.g. ''Waiting'', ''Testing Isolation'', ''Ready'', ''Error'')
-  *
-**Relays:** \\ Displays relay status (e.g. ''Open'', ''Closed'', ''Precharge'', ''Error'')
-''🔍 Always check both values before powering on or off the system manually.''