Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- mk3:hvrelaywirring [2025/04/07 15:31] – grnbms_tech
+++ mk3:hvrelaywirring [2025/06/25 09:54] (aktuell) – [Relay Control] grnbms
@@ Zeile 1: / Zeile 1: @@
 ==== High Voltage Relay Wiring – with Precharge ====
-''⚠️ **Disclaimer – Safety First!**''
+⚠️ **Disclaimer – Safety First!** \\
+The wiring diagrams and connection examples provided here are **suggestions only** and may not cover all edge cases or safety requirements.\\
-''The wiring diagrams and connection examples provided here are **suggestions only** and may not cover all edge cases or safety requirements. All high-voltage components must be installed and verified by a **qualified electrician** or professional installer. Incorrect wiring or misuse can lead to **severe damage, fire, or personal injury**. The manufacturer assumes **no liability** for damages resulting from improper installation or handling.''
+All high-voltage components must be installed and verified by a **qualified electrician** or professional installer.\\
+Incorrect wiring or misuse can lead to **severe damage, fire, or personal injury**.\\
+The manufacturer assumes **no liability** for damages resulting from improper installation or handling.
 Below is the recommended HV wiring setup for systems using **3 relays** and **precharge functionality**:
@@ Zeile 32: / Zeile 34: @@
 ==== Relay Control ====
-The GRNbms MK3 directly controls all three HV relays using integrated 12 V outputs. \\ Each relay is connected via its **dedicated connector**:
+The GRNbms MK3 directly controls all three HV relays using integrated 12 V outputs.\\
+Each relay is connected via its **dedicated connector**:
-  * **HV Relay Positive**
+   * **HV Relay Positive**
   * **HV Relay Negative**
   * **HV Relay Precharge**
@@ Zeile 42: / Zeile 45: @@
   * **No external power supply**  is needed – the BMS provides the 12 V directly
   * Each output is internally protected and current-limited
+👉 We recommend using relays with economizer to avoid unnecessary load on the BMS power supply
 ''✅ Just plug in your relays – the BMS handles power and timing automatically''