Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- mk3:hvrelaywirring [2025/04/07 15:15] – grnbms_tech
+++ mk3:hvrelaywirring [2025/06/25 09:54] (aktuell) – [Relay Control] grnbms
@@ Zeile 1: / Zeile 1: @@
 ==== High Voltage Relay Wiring – with Precharge ====
+⚠️ **Disclaimer – Safety First!** \\
+The wiring diagrams and connection examples provided here are **suggestions only** and may not cover all edge cases or safety requirements.\\
+All high-voltage components must be installed and verified by a **qualified electrician** or professional installer.\\
+Incorrect wiring or misuse can lead to **severe damage, fire, or personal injury**.\\
+The manufacturer assumes **no liability** for damages resulting from improper installation or handling.
 Below is the recommended HV wiring setup for systems using **3 relays** and **precharge functionality**:
@@ Zeile 12: / Zeile 18: @@
       * **Precharge Relay:**  Connects via precharge resistor to slowly charge input capacitors
       * **Positive Relay:**  Main high-side connection to the load
-      * **Negative Relay:**  Switches the low side (Battery -) to GND
+      * **Negative Relay:**  Switches the low side (Battery -)
   * **Precharge Resistor:**  Limits inrush current when first connecting to the inverter
   * **Current Shunt:**  Measures total current flow
@@ Zeile 25: / Zeile 31: @@
 👉 This wiring ensures proper current monitoring and safe soft-start of the system.
+==== Relay Control ====
+The GRNbms MK3 directly controls all three HV relays using integrated 12 V outputs.\\
+Each relay is connected via its **dedicated connector**:
+   * **HV Relay Positive**
+  * **HV Relay Negative**
+  * **HV Relay Precharge**
+=== Requirements: ===
+  * Relays must have a **12 V coil**
+  * **No external power supply**  is needed – the BMS provides the 12 V directly
+  * Each output is internally protected and current-limited
+👉 We recommend using relays with economizer to avoid unnecessary load on the BMS power supply
+''✅ Just plug in your relays – the BMS handles power and timing automatically''