Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- mk3:canbus [2025/04/07 17:03] – angelegt grnbms_tech
+++ mk3:canbus [2025/04/07 18:52] (aktuell) – grnbms_tech
@@ Zeile 3: / Zeile 3: @@
 To configure the CAN interface, go to **Connections → CAN Bus** in the sidebar.\\
 The settings box allows you to configure each available CAN bus individually.
+''You can find the CAN bus wiring guide [[:mk3:wirringcan|here]]''
 ==== Bus Selection ====
-Use the **dropdown menu** to select the CAN bus you want to configure, e.g. ''CAN1 Inverter'', ''CAN2 BMS'', etc.
+Use the **dropdown menu** to select the CAN bus you want to configure, e.g. ''CAN1 Inverter'', ''CAN2 CMU'', etc.
 ==== Baud Rate ====
@@ Zeile 27: / Zeile 29: @@
 To manually check termination, follow these steps:
-  -
+  * **Power off**  all devices on the CAN bus
+  * Measure the resistance between **CAN High and CAN Low**  using a multimeter
-**Power off**  all devices on the CAN bus
+      * Correct termination should show ~60 Ω (2× 120 Ω in parallel)
-  -
+      * 120 Ω indicates one terminator is missing
+  * Set the BMS's internal resistor accordingly using the dropdown
-Measure the resistance between **CAN High and CAN Low**  using a multimeter
-      *
-Correct termination should show ~60 Ω (2× 120 Ω in parallel)
-      *
- Ω indicates one terminator is missing
-  -
-Set the BMS's internal resistor accordingly using the dropdown
 ''⚠️ Proper termination is critical for reliable CAN communication. \\ Typically, one 120 Ω resistor is placed at **each end**  of the bus.''